Logo

Coach/Transit Bus

11.5.1 – Passenger Items

Passenger Entry/Lift

  • Check that entry doors operate smoothly and close securely from the inside.
  • Check that hand rails are secure and, if equipped, that the step light(s) are working.
  • Check that the entry steps are clear, with the treads not loose or worn excessively.
  • If equipped with a handicap lift, look for any leaking, damaged or missing part, and explain how it should be checked for correct operation.
  • Lift should be fully retracted and latched securely.

Emergency Exits

  • Make sure that all emergency exits are not damaged, operate smoothly, and close securely from the inside.
  • Check that any emergency exit warning devices are working.

Passenger Seating

  • Look for broken seat frames and check that seat frames are firmly attached to the floor.
  • Check that seat cushions are attached securely to the seat frames.

11.5.2 – Entry/Exit

Doors/Mirrors

  • Check that entry/exit doors are not damaged and operate smoothly from the outside. Hinges should be secure with seals intact.
  • Make sure that the passenger exit mirrors and all external mirrors and mirror brackets are not damaged and are mounted securely with no loose fittings.

11.5.3 – External Inspection of Coach/Transit Bus

Level/Air Leaks

  • See that the vehicle is sitting level (front and rear), and if air-equipped, check for audible air leaks from the suspension system.

Fuel Tank(s)

  • See that fuel tank(s) are secure with no leaks from tank(s) or lines.

Baggage Compartments

  • Check that baggage and all other exterior compartment doors are not damaged, operate properly, and latch securely.

Battery/Box

  • Wherever located, see that battery(s) are secure, connections are tight, and cell caps are present.
  • Battery connections should not show signs of excessive corrosion.
  • Check that battery box and cover or door is not damaged and is secure.

11.5.4 – Remainder of Coach/Transit Bus

Remainder of Vehicle

Please refer to Section 11.2 of this manual for detailed inspection procedures for the remainder of the vehicle.

Remember, the pre-trip inspection must be passed before you can proceed to the basic vehicle control skills test.

11.6 – Taking the CDL Pre-trip Inspection Test

11.6.1 – Class A Pre-trip Inspection Test

If you are applying for a Class A CDL, you will be required to perform one of the four versions of a pre-trip inspection in the vehicle you have brought with you for testing. Each of the four tests are equivalent and you will not know which test you will take until just before the testing begins.

All of the tests include an engine start, an in-cab-inspection, and an inspection of the coupling system. Then, your test may require an inspection of the entire vehicle or only a portion of the vehicle which your CDL Examiner will explain to you.

11.6.2 – Class B and C Pre-trip Inspection Test

If you are applying for a Class B CDL, you will be required to perform one of the three versions of a pre-trip inspection in the vehicle you have brought with you for testing. Each of the three tests are equivalent and you will not know which test you will take until just before the testing begins.

All of the tests include an engine start and an in-cab inspection. Then, your test may require an inspection of the entire vehicle or only a portion of the vehicle which your CDL Examiner will explain to you. You will also have to inspect any special features of your vehicle (e.g, school or transit bus).